Starting an Event and Starting Live Operation

Hint

  • An input source, output destination, and other settings must be configured beforehand in order to start an event. Configure settings on the [System] tab, [Router Input] tab, [Switcher Input] tab, [Output] tab, and [NDI Settings] tab of the [System Settings] screen.
  • Multiple events cannot be started at the same time. If a different event is already running, stop it and then start the desired event.

  1. To start an event, select an event on the [Dashboard] screen and press the [Start] button.
    The event status changes to “Starting” and the starting process begins. When the starting process is completed, the event status changes to “Running.”
  2. To perform live operation of an event, select a running event and press the [Live Operation] button.
    The [Live Operation] screen will appear.

To stop an event

Select a running event and press the [Stop] button. The event status changes to “Stopping” and the stopping process begins. When the stopping process is completed, the event status changes to “Stopped.”

Note

  • In rare cases where the status remains “Starting,” you can forcibly cancel the event by pressing the [Cancel] button. Note that tasks may not be completed successfully if there is a task in progress (including background operations) when forcibly canceled.
Go to Page Top
TP1001547624