Starting/Stopping Streaming
Note
- Streaming output is supported only when an event is in the “Running” state.
For streaming output, an output destination must be configured on the [Output] tab of the [System Settings] screen beforehand.
Press the [Start] button in the [Streaming] column on the [Output] tab of the [System Settings] screen. Preparation for streaming output begins and 
(Starting) is displayed on the left side of the button.
When streaming output starts, 
(Streaming output) is displayed on the left side of the button and the [Start] button changes to the [Stop] button.
When you press the [Stop] button, (Stopping) is displayed on the left side of the button and preparation for stopping streaming output begins. When stopped, (Stopping) disappears and the [Stop] button changes to the [Start] button.
You can also start/stop streaming output for all output destinations with [ID] of “4” to “33” for which [Start/Stop All] is enabled, at the same time, using the [Start All] button/[Stop All] button.
Note
- A short delay may occur after pressing each button until streaming output actually starts/stops.
- When [Streaming Type] is set to [SRT-Listener], [RTMP-Pull], or [RTMPS-Pull], (Streaming output) may be displayed even if a signal is not actually being output and is in standby mode, depending on the status of the other side.
