Cont. Bracket

still image

Shoots multiple images while automatically shifting the exposure from base to darker and then to lighter. You can select an image that suits your purpose after recording.

  1. Press / (Drive Mode) of the control wheel → [Cont. Bracket].
    • You can also set the drive mode by selecting MENU → (Shooting) → [Drive Mode] → [Drive Mode].
  2. Using the control wheel, select the desired exposure value and the number of images you want to shoot.
    • When setting to record two images, you can select whether to adjust the exposure to the + (over) or - (under) side.*
    • The [Bracket Settings] menu can be displayed with the right side of the control wheel.*

    * When the camera’s system software (firmware) version is Ver.4.00 or later

  3. Adjust the focus and shoot the image.
    • Keep pressing and holding the shutter button until bracket shooting is finished.

Menu item details

Exposure Value *:
Sets the amount by which the exposure value is adjusted during bracketing shooting.
Number of Shots *:
Sets the number of images to shoot during bracketing shooting.

* When the camera’s system software (firmware) version is Ver.4.00 or later

Hint

  • The last shot is shown on the auto review.

Note

  • When [ISO AUTO] is selected in [Manual Exposure] mode, the exposure is changed by adjusting the ISO value. If a setting other than [ISO AUTO] is selected, the exposure is changed by adjusting the shutter speed.
  • When the exposure is compensated, the exposure is shifted based on the compensated value.
  • Bracket shooting is unavailable in the following shooting modes:
    • [Intelligent Auto]
  • When the flash is used, the product performs flash bracket shooting, which shifts the amount of flash light even if [Cont. Bracket] is selected. Press the shutter button for each image.
Go to Page Top