XLR handle unit

Body parts

Illustration of the body parts of the XLR handle unit

  1. Microphone holder
  2. Cable holder
  3. Attachment screws
  4. Multi Interface foot


Switches and dials

Illustration of the switches and dials of the XLR handle unit

  1. ATT (INPUT1) switch

    Select the standard input level of the INPUT1 jack. This switch setting is active when the INPUT1 (LINE/MIC/MIC+48V) switch is set to “MIC” or “MIC+48V.”

  2. INPUT1 (LINE/MIC/MIC+48V) switch

    Select the option suitable for the device connected to the INPUT1 jack.

  3. ATT (INPUT2) switch

    Select the standard input level of the INPUT2 jack. This switch setting is active when the INPUT2 (LINE/MIC/MIC+48V) switch is set to “MIC” or “MIC+48V.”

  4. INPUT2 (LINE/MIC/MIC+48V) switch

    Select the option suitable for the device connected to the INPUT2 jack.

  5. LOW CUT (INPUT1) switch

    Use this switch to minimize unwanted noise by attenuating low-frequency components of the input audio from the INPUT1 jack.

  6. AUTO/MAN (INPUT3) switch

    Select the method (Auto/Manual) for adjusting the volume level of the input audio from the INPUT3 jack.

  7. AUTO/MAN (INPUT1) switch

    Select the method (Auto/Manual) for adjusting the volume level of the input audio from the INPUT1 jack.

  8. AUDIO LEVEL (INPUT1) dial

    Adjust the recording volume level of the input audio from the INPUT1 jack.

  9. AUTO/MAN/LINK (INPUT2) switch

    Select the method (Auto/Manual/Link to INPUT1) for adjusting the volume level of the input audio from the INPUT2 jack.

  10. AUDIO LEVEL (INPUT2) dial

    Adjust the recording volume level of the input audio from the INPUT2 jack.

  11. LOW CUT (INPUT2) switch

    Use this switch to minimize unwanted noise by attenuating low-frequency components of the input audio from the INPUT2 jack.

  12. AUDIO LEVEL (INPUT3) dial

    Adjust the recording volume level of the input audio from the INPUT3 jack.

  13. INPUT SELECT switch

    Select the audio input for recording audio to the channels on the attached camera.

  14. HANDLE AUDIO switch

    Enable audio input from the XLR adaptor.


Ports and jacks

Illustration of the jacks of the XLR handle unit

  1. INPUT3 jack (stereo mini-jack, plug-in-power compatible)
  2. Release lever
  3. INPUT2 jack (3-pin XLR/TRS, female type, phantom-power compatible)
  4. INPUT1 jack (3-pin XLR/TRS, female type, phantom-power compatible)
  5. Micro USB port

Note

  • Do not touch the connectors with bare hands.