[PROTECTOR] or [THERMAL] appears on the display panel.
The unit will automatically turn off after a few seconds. Check the followings:
- There may be an electrical surge or power failure. Unplug the AC power cord (mains lead) and then plug in the cord again after 30 minutes.
- The unit is covered and the ventilation holes are blocked. Remove the object covering the ventilation holes of the unit.
- The impedance of the connected speakers is below the rated impedance range indicated on the back panel of the unit. Reduce the volume level.
- Unplug the AC power cord (mains lead) and let the unit cool down for 30 minutes while performing the following troubleshooting:
- Disconnect all of the speakers and subwoofer.
- Check that the speaker wires are tightly twisted on both ends.
- Connect the front speaker first, increase the volume level and operate the unit for at least 30 minutes until it completely warms up. Then, connect each additional speaker one by one and test each additional speaker until you detect which speaker is causing the protection error.
After checking the above items and fixing any problems, plug in the AC power cord (mains lead) and turn on the unit. If the problem persists, consult your nearest Sony dealer.
