Connecting 5.1.2-channel speaker system using front Dolby Atmos enabled speakers

Connect each speaker to the SPEAKERS terminals on the rear of the unit.

Before connecting cables, be sure to disconnect the AC power cord (mains lead).

For details on how to connect speaker cables to the unit, see “How to connect speaker cables.”

Illustration of connecting each speaker to the speaker terminals on the rear of the unit. Connect the left and right front speakers, left and right surround speakers, left and right front Dolby Atmos enabled speakers, and center speaker to their respective speaker terminals using speaker cables (not supplied). Connect the subwoofer to the SUBWOOFER OUT terminal with a monaural audio cable (not supplied).

Monaural audio cable (not supplied)

Speaker cable (not supplied)

After connecting Dolby Atmos-enabled speakers, set [Speaker Pattern] in [Manual Speaker Settings] under [Speaker Settings] to [5.1.2 (FD)].

Note

  • Connect speakers with a nominal impedance of 6 ohms to 16 ohms.
Go to Page Top