Assigning a Story to a Camcorder
Use the following procedure to assign a story to a camcorder on the [Planning] screen.
Note
- The system can also be configured to assign a story to a camcorder automatically, bypassing the following procedure. For details, refer to the Help Guide (Setup).
-
Display the story to assign in the story operation area.
-
Place a check mark in the checkbox for the story to assign.
-
Select the group that includes the camcorder to which you want to assign the story in the [Group] area.
-
Place a check mark in the checkbox for the target camcorder in the assignment selection area.
-
Click the [Assign] button.
Note
- If a story with the same title as an existing story is assigned to a camcorder, the new story overwrites the previous story.
- To load the story into a camcorder, sending and loading are required.
For details, see “Loading a Story into a Camcorder.” - For a group that receives stories from a network-type planning interface, the status of the assigned story will not be updated if communication between C3 Portal and the planning interface cannot be established.
- Select a story and click the
(Menu) button and select [Details…] to display the [Details] dialog. You can check the sending status details in the [Details] dialog.
- There is a limit to the number of stories that can be stored on a camcorder. For details, refer to the operating instructions of the camcorder.
To assign multiple stories to a camcorder
Place a check mark in the checkbox for the stories in the story operation area.
To assign a story to multiple camcorders
Place a check mark in the checkbox for the target camcorders in the assignment selection area.
Note
- To check which camcorders were assigned the story, select the story in the story operation area, click the
(Menu) button, and select [Details…] to display the [Details] dialog..
To view details of a story
Select a story in the story operation area to display the details in the story information area.
To cancel a story assignment
Select the story you want to cancel in the [Assigned Metadata] area and click (Delete).
Note
- The status display in the [Assigned Metadata] area is not updated automatically. To update the display, click the [Reload] button.