Side view

  1. LAN terminal
  2. (Flash sync) terminal
  3. Speaker
  4. (Microphone) jack

    When an external microphone is connected, the built-in microphone turns off automatically. When the external microphone is a plugin-power type, the power of the microphone is supplied by the camera.

  5. (Headphones) jack
  6. HDMI micro jack
  7. USB Type-C terminal
  8. Multi/Micro USB Terminal*

    This terminal supports Micro USB-compatible devices.

  9. Charge lamp
  10. Hooks for shoulder strap

    Attach both ends of the strap onto the camera.

  11. (N-Mark)
    • This mark indicates the touch point for connecting the camera and an NFC-enabled Smartphone.

    • NFC (Near Field Communication) is an international standard of short-range wireless communication technology.
  12. SLOT 1 (Memory card slot 1)

    Supports SD cards only (compatible with UHS-I and UHS-II)

  13. SLOT 2 (Memory card slot 2)

    Supports SD cards only (compatible with UHS-I and UHS-II)


* For details on compatible accessories for the Multi/Micro USB Terminal, visit the Sony website, or consult your Sony dealer or local authorized Sony service facility.


Notes on USB terminals

You can use either the USB Type-C terminal or the Multi/Micro USB Terminal for supplying power, charging the battery, and USB communications. However, you cannot conduct these operations with both terminals simultaneously.

  • The battery charging time does not change according to the terminal you use.
  • You can use accessories for the Multi/Micro USB Terminal, such as a remote commander (sold separately), while supplying power or performing PC Remote shooting using the USB Type-C terminal.


Notes on the terminal cover

Ensure that the terminal cover is closed before use.


Notes on the cable protector

Use the cable protector to prevent a cable from being disconnected when shooting images with the cable connected.


To attach the cable protector

  1. Open both of the jack covers on the monitor side.
  2. Fit the two hooks (A) on the rear side of the cable protector into the two notches (B) to the left of the USB Type-C terminal and Multi/Micro USB Terminal, and then align the cable protector with the terminal part of the camera.
  3. Push the attachment screw (C) in and turn it to secure the cable protector.

  4. Insert the cable into one of the jacks.
  5. Insert the cable into the holding part and then secure the cable with the fixing dial (D).


To remove the cable protector

Loosen the attachment screw, and then remove the cable protector.

Go to Page Top