Identifying parts

Rear side

Illustration of the rear side of the camera

  1. LOCK switch
  2. (Enlarge) button

    During playback, you can enlarge the playback screen.

    When shooting, you can use the functions assigned in the custom key settings. The function for shooting is not assigned by default. Assign your desired function using the custom key settings.

  3. ON/OFF (Power) switch
  4. Power lamp

    When lit up in green: Power is being supplied, and the ON/OFF (power) switch is turned on

    When lit up in red: Power is being supplied, and the ON/OFF (power) switch is turned off

  5. Memory card cover switch
  6. Access lamp
  7. Memory card slot
  8. Memory card cover
  9. MENU button
  10. For shooting: C button (Custom button)
    For viewing: (Delete) button
  11. Control wheel
  12. (Playback) button
  13. Still/Movie/S&Q switch
  14. Shutter/MOVIE (Movie) button
  15. Power & Control terminal

    Illustration of the rear side of the camera

  16. USB Type-C fixing screw hole
  17. USB Type-C terminal
  18. HDMI micro jack

Front side

Illustration of the camera without the lens

  1. Mounting index
  2. Image sensor*
  3. Mount
  4. Lens contacts*
  5. Lens release button

    Illustration of the front side of the camera

  6. Image sensor position mark
    • The image sensor is the sensor that converts light into an electric signal. The position of the image sensor is indicated by (Image sensor position mark). When you measure the exact distance between the camera and the subject, refer to the position of the horizontal line.
    • If the subject is closer than the minimum shooting distance of the lens, the focus cannot be confirmed. Make sure you put enough distance between the subject and the camera.
  7. Recording lamp
  8. Lens


* Do not directly touch these parts.


Bottom

Illustration of the bottom of the camera

  1. Tripod socket hole
    Supports 1/4-20 UNC screws

    Use a tripod, etc. with a screw less than 5.5 mm (7/32 inches) long (Recommended tightening torque: 2.0 N・m).
    Otherwise, you cannot firmly secure the camera, and damage to the camera may occur.


Fixing (M3) screw holes

Use M3 screws less than 4.5 mm (3/16 inches) long (Recommended tightening torque: 0.6 N・m).

If you use screws with dimensions other than those specified, you may not be able to secure this product firmly and may damage it.

Fixing screw holes can be found in the following locations.

  • Front: 4 locations
  • Rear: 4 locations
  • Top: 4 locations
  • Sides: 2 locations on each side
  • Bottom: 4 locations

Illustration indicating the positions of the fixing screw holes

TP1001221893