Configuring the Network Settings of the Projector

You can configure the network settings on the [Network] page in [Advanced Settings].

Note

  • The entered value will not be applied until the [Apply] button is clicked.
  1. Select [Advanced Settings] - [Network] and display the [Network] page.

  2. Configure the [IPv4 Setting] and [IPv6 Setting] items.
  3. Check the items in [Ethernet].

    The MAC address of the projector is displayed at [MAC Address].

  4. Click the [Apply] button.

Settings

[IPv4 Setting]

  • [IP Address Setup]: You can select the IP address setting method.
    • [Auto(DHCP)]: Network settings are automatically assigned by the DHCP server functions such as the router.
    • [Manual]: Network settings are configured manually.
  • [IP Address]: The IP address of the projector is set.
  • [Subnet Mask]: The subnet mask of the projector is set.
  • [Default Gateway]: The default gateway of the projector is set.

[IPV6 Setting]

  • [IP Address Setup]: You can select the IP address setting method.
    • [Auto]: Network settings are automatically assigned.
    • [Manual]: Network settings are configured manually.
  • [IP Address]: The IP address of the projector is set.
  • [Prefix]: The prefix length (bit) is set.
  • [Default Gateway]: The default gateway of the projector is set.
Go to Page Top