Menu Operation: Aspect
You can set the aspect ratio of the image to be projected for the current input signal.
-
Press the MENU button.
-
Select
[Screen] - [Aspect] - the desired setting.
Settings
[Full 1]
4096 × 2160 images are projected across the entire screen while maintaining the aspect ratio.
[Full 2]
4096 × 2160 images are projected across the entire screen.
[Normal]
Input image is projected on the entire screen with the aspect ratio maintained. This is suitable for viewing 1.78:1 (16:9) and 1.33:1 (4:3) images.
[V Stretch]
This is most suitable for viewing the 2.35:1 image on the 2.35:1 screen with a commercially available anamorphic lens. When you select [V Stretch] under [Trigger Select] in the 
[Installation] menu, a 12 V signal is output from the TRIGGER terminal.
[Squeeze]
When you view the 1.78:1 (16:9) or 1.33:1 (4:3) image with a commercially available anamorphic lens, the image is projected with the correct aspect ratio.
[Stretch]
The image squeezed to 1.33:1 (4:3) is projected with 1.78:1 (16:9) aspect ratio.
Hint
- When you select [V Stretch] or [Squeeze], select the anamorphic lens type according to your anamorphic lens under [Anamorphic Lens] in the [Installation] menu.
- Selectable aspect settings vary depending on an input signal.
- When a computer signal is input, you cannot select the aspect settings.
- The aspect setting is saved for each of the five Picture Positions. Select the Picture Position before adjusting the aspect. Final adjusted values are saved automatically.
- You can also set [Aspect] with the ASPECT button on the remote control.
