Menu Operation: Picture Position
You can save up to three combinations of lens settings, aspect ratio, and blanking.
-
Press the MENU button.
-
Select
[Screen] - [Picture Position]. -
After setting the lens (focus, image size, image position), select the desired position from [Custom 1] to [Custom 5] according to the adjusted screen aspect-ratio. Then confirm the selected position.
-
Select [Save], [Delete], or [Select].
Settings
[Save]
The current lens settings (focus, image size, image position) are saved in the selected position. If another setting has already been saved in the position, it is overwritten.
[Delete]
The saved setting is deleted. After the setting is deleted, [Custom 1] to [Custom 5] are changed to [---] in the display.
[Select]
The settings of the selected position are recalled.
Hint
- It is recommended to first move down by 5 cm (2 inches) or more from the desired point, then move up before saving the Picture Position. This improves the precision of the Picture Position when it is recalled.
- You can also set [Picture Position] with the POSITION button on the remote control.
Note
- When the position has been selected and then confirmed, the lens starts to move. Do not touch the lens and place anything near the lens. Doing so may cause injury or malfunction.
- If you press any button on the remote control or the control panel while the lens is moving, the lens stops. In that case, select the position again or adjust the lens manually.
- If you use a 2.35:1 aspect ratio and a 16:9 aspect ratio together with the Picture Position function, make sure that the installation position of the projector is suitable.
- The Picture Position function is not guaranteed to reproduce the lens settings precisely.
