When you have finished using the headset
When you have finished using the headset, be sure to set the headset into the charging case.
Put the left unit of the headset (the unit with the tactile dot) back into the left hole of the charging case, put the right unit of the headset back into the right hole of the charging case, insert the units until they click, and then make sure that the units are locked in the charging case.
Close the lid of the charging case.
Note
- If perspiration or water is left on the charging port, it may impair the ability to charge the headset. Immediately wipe off any perspiration or water on the charging port after use. When the charging ports of the headset or charging case get dirty, wipe them clean with a soft dry cloth.
A: Charging ports of the headset units
B: Charging ports of the charging case
When the headset gets wet
- Use a soft dry cloth to wipe off any water that gets on the headset.
-
Turn the sound output part downward and gently tap it about 10 times on a dry cloth, etc. to remove any water collected inside.
-
Turn the microphone part downward and gently tap it about 5 times on a dry cloth, etc. to remove any water collected inside.
- Leave the headset to dry in room temperature.
