Outputting a test tone from each speaker (Test Tone)

You can output a test tone from each speaker in sequence.

  1. Select [Setup] - [Speaker Settings] from the home menu.
  2. Select [Manual Speaker Settings].
  3. Select [Test Tone].
  4. Select the setting you want.
    • Off
    • Auto: The test tone is output from each speaker in sequence.
    • Front (L), Center 1 (*1), Center 2 (*1), Center (*2), TV Center, Front (R), Front Wide (L) (*3), Front Wide (R) (*3), Surround (L), Surround (R), Surround Back (L), Surround Back (R), Height1 (L), Height1 (R), Height2 (L), Height2 (R), Height3 (L) (*3), Height3 (R) (*3), Top Front (L) (*3), Top Center (*3), Top Front (R) (*3), Top Rear (R) (*3), Top Rear (L) (*3), Bottom Front (L) (*3), Bottom Center (*3), Bottom Front (R) (*3), Subwoofer: You can select which speakers will output the test tone.

      *1 for STR-AZ7000ES/STR-AZ5000ES

      *2 for STR-AZ3000ES

      *3 for STR-AZ7000ES

  5. Adjust the speaker level.

Hint

  • You can set a test tone by pressing the TEST button on the remote control. In this case, you can only use the display panel for the operation.
  • To adjust the level of all speakers at the same time, press (volume) +/–. You can also use MASTER VOLUME on the receiver.
  • The adjusted value is shown on the TV screen during adjustment.