Connecting a TV with jacks other than HDMI jacks

Connect a TV to the VIDEO OUT MONITOR jack.

In addition to connecting with the video cable (), it is necessary to connect with an optical digital audio cable () or audio cable ().

Be sure to disconnect the AC power cord (mains lead) before connecting cables.

Connecting with a video cable and an optical digital cable (recommended)

Illustration of connecting the TV and receiver. Connect the VIDEO OUT MONITOR jack on the rear of the receiver with the VIDEO INPUT jack on your TV using a video cable (not supplied). Connect the DIGITAL OPTICAL IN 2 (TV) jack on the rear of the receiver with the DIGITAL OPTICAL OUTPUT jack on the rear of your TV using an optical digital cable (not supplied).

Connecting with a video cable and an audio cable (recommended)

Illustration of connecting the TV and receiver. Connect the VIDEO OUT MONITOR jack on the rear of the receiver with the VIDEO INPUT jack on the rear of your TV using a video cable (not supplied). Connect the TV AUDIO IN jacks on the rear of the receiver with the AUDIO OUTPUT jacks on the rear of your TV using an audio cable (not supplied).

Video cable (not supplied)

Optical digital cable (not supplied)

Audio cable (not supplied)

Note

  • When the above connection is made, only the video from the device connected to the VIDEO IN jacks is displayed on the TV screen.
  • When the above connection is made, the menu cannot be displayed. Connect with an HDMI cable to operate the receiver using the menu.
  • Depending on the status of the connection between the TV and the antenna (aerial), the image on the TV screen may be distorted. If this is the case, place the antenna (aerial) farther away from the receiver.

Hint

  • When connecting a TV to the receiver via the TV AUDIO IN jacks of the receiver, set the sound output jack of the TV to “Fixed” if it can be switched between “Fixed” or “Variable.”
Go to Page Top