Checking Auto Calibration results

To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:

If an error code appears

Check the error and perform Auto Calibration again.

  1. Select [Retry].
  2. Follow the instructions on the TV screen to perform Auto Calibration.

    Auto Calibration is performed twice.

  3. When the measurement is completed, select the item you want.
    • Save: Saves the measurement results and exits the setting process.
    • Retry: Performs the Auto Calibration again.
    • Discard: Exits the setting process without saving the measurement results.
  4. Save the measurement results.

    Select [Save] in step 3.

  5. If the [SpeakerRelocation / PhantomSurroundBack] function screen is displayed, select the desired setting by referring to “Calibrating speaker positioning (SpeakerRelocation / PhantomSurroundBack).”

    If [In-Ceiling Speaker Mode] is set to [Front & Center] or [Front], this screen will not be displayed, so proceed to step 6.

  6. Select the desired calibration type by referring to “Selecting the Auto Calibration type (Calibration Type).”
  7. When the calibration matching function screen is displayed, select [Yes] or [No].
    • Yes: By expanding the sweet spot of the listening position and adjusting the sound wave on the left and right of each speaker, you can enjoy more natural sound.
    • No: The measurement result of the Auto Calibration is applied as it is.
  8. Perform the 360 Spatial Sound Mapping demo as needed.

If a warning message appears

Check the warning message and select [OK]. For details on the warning messages, see “List of messages after Auto Calibration measurements.”

Hint

  • The measurement results may vary depending on the position of the subwoofer. However, continuing to use the receiver with that value does not cause problems.
Go to Page Top