Switching the TVs that output the HDMI video signals

If [HDMI OUT B Mode] is set to [Main] and you have connected two TVs to the HDMI OUT A and HDMI OUT B (ZONE 2) jacks, you can switch the output for these two TVs using the HDMI OUTPUT button on the remote control.

  1. Connect two TVs to the receiver, and then turn on the receiver and the two TVs.
  2. Press HDMI OUTPUT.

    Each time you press the button, the output will be switched as follows:

    [HDMI OUT A] - [HDMI OUT B] (*) - [HDMI OUT A+B] (*) - [HDMI OUT OFF]

    *Unavailable when [HDMI OUT B Mode] is set to [Zone2].

Note

  • [HDMI OUT A+B] may not work if the compatible video formats of the TVs connected to the HDMI OUT A jack and the HDMI OUT B (ZONE 2) jack of the receiver are different.
  • [HDMI OUT A+B] may not work depending on the playback device you connect.
  • When you connect two Dolby Vision-compatible TVs to the receiver and select [HDMI OUT A+B], Dolby Vision content is output in the HDR10 or SDR (Standard Dynamic Range) format. To enjoy Dolby Vision content as it is, connect only one Dolby Vision-compatible TV to the receiver, or select either [HDMI OUT A] or [HDMI OUT B].
  • If [HDMI OUT B Mode] is set to [Zone2], you cannot select [HDMI B] and [HDMI A+B].
  • When [HDMI OUT B Mode] is set to [Zone2], the HDMI signals are output to the Zone 2 even if [HDMI OFF] is selected.

Hint

  • You can also use HDMI OUT on the receiver to switch the TV.