Setting the Zone 2 HDMI audio output of connected devices (Zone2 Audio Out)

You can set the Zone 2 HDMI audio signal output for playback devices connected to the receiver via an HDMI connection.

  1. Select [Setup] - [HDMI Settings] from the home menu.
  2. Select [Zone2 Audio Out].
  3. Select the setting you want.

    • AMP: Recommended setting when a TV is connected directly to the HDMI OUT B (ZONE 2) jack.
      Sound is output from the speakers connected to the receiver.
      Sound is not output from the TV speakers.

    • Zone2 TV + AMP: Recommended setting when a TV is connected directly to the HDMI OUT B (ZONE 2) jack.
      Sound is output from the TV speakers and the speakers connected to the receiver.

    • Zone2 AMP: Recommended setting when another amplifier is connected to the HDMI OUT B (ZONE 2) jack.
      Sound is output from the another amplifier connected to the HDMI OUT B (ZONE 2) jack.
      Sound is not output from the SPEAKERS SURROUND BACK/HEIGHT terminals and the ZONE 2 AUDIO OUT jacks.

Note

  • You can only configure this setting when [HDMI OUT B Mode] is set to [Zone2].
  • When a video device (projector, etc.) is connected to the HDMI OUT B (ZONE 2) jack, sound may not be output from the receiver. In this case, set [Zone2 Audio Out] to [AMP].
  • When a TV which does not support audio content protection is connected to the HDMI OUT B (ZONE 2) jack, specific audio may not be output from the receiver. In this case, set [Zone2 Audio Out] to [AMP].
  • When [Zone2 Audio Out] is set to [Zone2 TV + AMP] or [AMP], audio signals will be downmixed. The following restrictions apply to downmixing.
    • If you change the sound field or speaker settings in the main zone while the input for Zone 2 is set to [SOURCE] or the same input is selected in the main zone and Zone 2, the sound may also be momentarily interrupted in Zone 2.
    • The D.L.L. function does not work in the main zone.
    • The volume level of sound from the SPEAKERS SURROUND BACK/HEIGHT terminals and the HDMI OUT B (ZONE 2) jack may be different from sound that is not downmixed.
  • No sound will be output to Zone 2 if you play a DTS-CD with different HDMI inputs selected in the main zone and Zone 2.
  • You cannot remedy the time gap between video output on the TV connected to the HDMI OUT B (ZONE 2) jack and audio output from the speaker connected to the SPEAKERS SURROUND BACK/HEIGHT terminals using the [A/V Sync] function.
Go to Page Top