Auto Calibration operation
Auto Calibration is performed twice.
- 1st calibration: Place the microphone on the mic stand top (
). - 2nd calibration: Rotate the microphone 90 degrees and place it on the mic stand bottom (
).
Note
- The speakers emit very loud sound during the calibration and the volume cannot be adjusted. If the muting function has been activated before you perform Auto Calibration, the muting function will shut off automatically.
- It may not be possible to take the correct measurements or to perform Auto Calibration at all if special speakers such as dipole speakers are used.
- If the measurement fails, follow the message, then select [Retry]. For details on the error code and warning message, see “List of messages after Auto Calibration measurements.”
To cancel Auto Calibration
The Auto Calibration function will be canceled when you perform the following operations, etc. during the measurement process:
- Press
(power). - Press the input buttons on the remote control or on the receiver.
- Press HOME, AMP MENU, HDMI OUT or
(muting) on the remote control. - Press SPEAKERS on the receiver.
- Change the volume level.
