Starting/Stopping the Sending of Video for Auto Highlight Creation
Note
- To send video for auto highlight creation, the following conditions must be satisfied.
- An A2 Production subscription exists.
The [Start] button is not displayed unless you have a subscription with A2 Production. - Using Professional ID.
The [Start] button is not displayed when using a Sony account. - Event status is “Running,” [Analysis Rule] is configured, and [Video Format] is set to an H.264 format with progressive scan method for the output destination with [ID] of 1.
The [Start] button is disabled in all cases except the above. To configure [Analysis Rule], you must log in to A2 Production and agree to the terms of use and privacy policy.
- An A2 Production subscription exists.
To send video for auto highlight creation, the output destination with [ID] of 1 must be configured in the [Output] list on the [System Settings] screen beforehand.
Press the [Start] button in the [Auto Highlight] column in the [Output] list to start sending video for auto highlight creation. The [Start] button changes to the [Stop] button. During the sending of video, 
(Sending) is displayed on the left side of the button.
Press the [Stop] button to stop sending video. The [Stop] button changes to the [Start] button.
Note
- A short delay may occur after pressing the [Start]/[Stop] button until sending video actually starts/stops.
