How to control FL-N01
You can operate FL-N01 with your voice.
This section shows you how to use FL-N01 following an example to check the time.
- Set FL-N01 to ready for operation.
Select one of the following methods to set FL-N01 to ready for operation.
- Tell FL-N01 “Listen up Nigel*1.”
- Press the voice input button on FL-N01.
You will hear a sound*2 from FL-N01 which reminds you that FL-N01 is ready for operation.
- Within a few seconds after hearing the sound, tell FL-N01 "What time is it?."
You will hear a sound*3 from FL-N01 which reminds you that FL-N01 has received your voice input.
- When you hear the error sound*4 and "Failed to recognize. Try one more time." from FL-N01
- Check for the sound*2 that indicates FL-N01 is ready for operation.
- Tell FL-N01 "What time is it?" again.
You do not need to go back to step .
- When you hear the error sound*4 and "Failed to recognize." from FL-N01
- Go back to step and try the procedures again.
- When you hear the error sound*4 and "Failed to recognize. Try one more time." from FL-N01
- FL-N01 tells you the time.
To cancel inputting voice command
After step , press the voice input button on FL-N01.
If you cannot control FL-N01 well
- FL-N01 may not work correctly depending on the ambient noise.
- Make sure that FL-N01 is not covered with cloth such as a collar, etc.
- Depending on the voice commands, a network connection is required. For details, see "Voice command/Natural speech list."
- If FL-N01 hardly accepts your voice command, try the following.
- Avoid places where loud noise, strong wind, or the echo effect occurs.
- Try again from step .
- Try saying another phrase if you intend to control FL-N01 with your speech.
Note
- It may take as long as 10 seconds for FL-N01 to tell you information after it has received your voice input.
- FL-N01 is released from the ready for operation status when no voice input is sent within 4 seconds after you hear a sound from FL-N01 which reminds you that FL-N01 is ready for operation (step ). In this case, go back to step .