Taking photos at intervals

You can take photos at intervals with FL-N01 by using the built-in camera.

  1. Perform initial setup and camera settings on the “Future Lab Program N” app.
  2. Set FL-N01 to ready for operation.

    Select one of the following methods to set FL-N01 to ready for operation.

    • Tell FL-N01 “Listen up Nigel*1.”

    • Press the voice input button on FL-N01.

    You hear a sound*2 from FL-N01 which reminds you that FL-N01 is ready for operation.

  3. Within a few seconds after hearing the sound, tell FL-N01 "Start interval photo shooting."

    You will hear a sound*3 from FL-N01 which reminds you that FL-N01 has received your voice input.

    • When you hear the error sound*4 and "Failed to recognize. Try one more time." from FL-N01
      • Check for the sound*2 that indicates FL-N01 is ready for operation.
      • Tell FL-N01 "Start interval photo shooting" again.

      You do not need to go back to step .

    • When you hear the error sound*4 and "Failed to recognize." from FL-N01
      • Go back to step and try the procedures again.
  4. FL-N01 takes photos at intervals.

    Photo data will be stored in FL-N01. You can see them by connecting FL-N01 to a computer.

To cancel inputting voice command

After step , press the voice input button on FL-N01.

If you cannot control FL-N01 well

See "How to control FL-N01" for details.

To stop taking photos at intervals

1. Set FL-N01 ready for operation by telling FL-N01 “Listen up Nigel” or pressing the voice input button on FL-N01.

2. Within a few seconds after hearing the sound from FL-N01 which reminds you that FL-N01 is ready for operation, tell FL-N01 "Stop interval photo."

Hint

  • The camera will be adjusted automatically to maintain the horizontal position while you are walking or cycling.
Go to Page Top