Outputting a test tone from each speaker “T. TONE

You can output a test tone from each speaker in sequence.
This operation is only available using the display panel on the front of the receiver.

  1. Press AMP MENU.
  2. Select “<LEVEL>” - “T. TONE” on the display panel.
  3. Select the setting you want.
    • OFF
    • AUTO XXX (*): The test tone is output from each speaker in sequence.

    * XXX represents a speaker channel (FL, CNT, FR, SR, SBR, SBL, SL, HL, HR, SW). The speaker channels that appear on the display panel vary depending on the speaker pattern settings.



    If you need to adjust the speaker level according to the results of outputting a test tone, refer to “Adjusting the speaker level [Level]” for how to adjust the level.

Hint

  • To adjust the level of all speakers at the same time, press +/–. You can also use MASTER VOLUME on the receiver. The adjusted value is shown on the display panel during adjustment.