Adjusting the crossover frequency settings for IMAX Enhanced content playback (IMAX ADJUSTMENT)

When you watch IMAX Enhanced content, the following settings are deactivated so as not to interfere with the sound of the content.

  • [2.12. CROSSOVER FREQUENCY]
  • [4.6. SUBWOOFER LOW PASS FILTER]

However, IMAX Enhanced content may not be reproduced adequately depending on the size and specifications of your speakers.

If adjustment is necessary when watching IMAX Enhanced content, perform the following operations.

The function only works when a DTS stream is input.

  • Adjusting the crossover frequency for front, center, surround, and/or height speaker output
  • Adjusting the crossover frequency for the subwoofer output

Adjusting the crossover frequency for front, center, surround, and/or height speaker output

  1. Press AMP MENU.

    The menu is displayed on the display panel of the receiver.

  2. Press / repeatedly to select [4. AUDIO SETUP], then press .

  3. Press / repeatedly to select [4.13. IMAX ADJUSTMENT], then press .

  4. Press / repeatedly to select [4.13.1. HPF/CROSSOVER], then press .

  5. Press / repeatedly to select the speaker for which you want to adjust the crossover frequency, then press .

    You can select from the following speakers.

    FRONT, CENTER, SURROUND, HEIGHT1 or HEIGHT2

  6. Press / repeatedly to select a setting between 40 Hz and 200 Hz, then press .

Adjusting the crossover frequency for the subwoofer output

  1. Press AMP MENU.

    The menu is displayed on the display panel of the receiver.

  2. Press / repeatedly to select [4. AUDIO SETUP], then press .

  3. Press / repeatedly to select [4.13. IMAX ADJUSTMENT], then press .

  4. Press / repeatedly to select [4.13.2. LPF FOR SUBWOOFER], then press .

  5. Press / repeatedly to select a setting between 40 Hz and 200 Hz, then press .

Note

  • The setting value for surround speakers is applied to surround back speakers.
Go to Page Top