6. Checking Auto Calibration results

To check error codes or warning messages received in Auto Calibration, proceed with the following steps:

If an error code appears

Check the error and perform Auto Calibration again.

  1. Select [Retry].
  2. Follow the instructions on the TV screen and then press to select [Start].

    The measurement starts in a few seconds.
    The measurement process will take approximately 30 seconds with a test tone.
    When the measurement ends, a beep sounds and the screen switches.

  3. Select the item you want.
    • Retry: Performs the Auto Calibration again.
    • Save&Exit: Saves the measurement results and exits the setting process.
    • Exit: Exits the setting process without saving the measurement results.
  4. Save the measurement results.

    Select [Save&Exit] in step 3.

If a warning message appears

Check the warning message and select [OK]. For details on the warning messages, see “List of messages after Auto Calibration measurements.”

Hint

  • The measurement results may vary depending on the position of the subwoofer. However, continuing to use the receiver with that value does not cause problems.
Go to Page Top