List of messages after Auto Calibration measurements

  • Code 30:
    Headphones are connected to the PHONES jack on the receiver. Remove the headphones and perform the Auto Calibration again.
  • Code 31:
    Front speakers are not selected properly. Select the front speakers using SPEAKERS on the receiver and perform the Auto Calibration again.
  • Code 32, Code 33:
    • Speakers were not detected or not connected properly.
      • None of the front speakers are connected or only one front speaker is connected.
      • Either the surround left or surround right speaker is not connected.
      • Surround back speakers or front high speakers are connected even though surround speakers are not connected. Connect the surround speaker(s) to the SPEAKERS SURROUND/ZONE 3 terminals.
      • A surround back speaker is connected only to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B R terminal. If connecting only one surround back speaker, connect it to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B L terminal.
      • Either the front high left or front high right speaker is not connected.
    • The calibration microphone is not connected. Make sure that the calibration microphone is connected properly and perform the Auto Calibration again. If the calibration microphone is connected properly but the error code still appears, the calibration microphone cable may be damaged.
  • Warning 40:
    The measurement process has been completed and a high noise level has been detected. You may be able to achieve better results if you try the process again in a quiet environment.
  • Warning 41, Warning 42:
    • The input from the microphone is too large.
    • The distance between the speaker and the microphone may be too short. Set them further apart and perform the measurement again.
  • Warning 43:
    The distance and phase of a subwoofer cannot be detected. This may be caused by noise. Try performing the measurement in a quiet environment.
Go to Page Top