Self-timer(Single)

still image

Shoots an image using the self-timer after a designated number of seconds have elapsed since the shutter button was pressed. Use the 5-second/10-second self-timer when you are going to be in the picture, and use the 2-second self-timer to reduce camera-shake caused by pressing the shutter button.

  1. Select (Self-timer) by turning the drive mode dial.
    • Turn the drive mode dial while holding down the drive mode dial lock release button.
  2. MENU → (Shooting) → [Drive Mode] → [Self-timer Type] → [Self-timer(Single)] → desired mode.
    • If you register [Drive Mode] to the function menu, you can also display the setting screen for [Self-timer Type] from the function menu.
  3. Adjust the focus and shoot the image.
    The self-timer lamp flashes, a beep sounds, and a picture is taken after the designated number of seconds have elapsed.

Menu item details

The mode determines the number of seconds until a picture is taken after the shutter button is pressed.

Self-timer(Single): 10 sec
Self-timer(Single): 5 sec
Self-timer(Single): 2 sec


To set the drive mode using MENU

When the drive mode dial is set to (disabled), you can set the drive mode in MENU.

MENU → (Shooting) → [Drive Mode] → [Drive Mode] → [Self-timer(Single)].

Hint

  • Press the shutter button again to stop the count of the self-timer.
  • Select a drive mode other than (Self-timer) by turning the drive mode dial to cancel the self-timer. To cancel the self-timer when the drive mode dial is set to (disabled), select MENU → (Shooting) → [Drive Mode]→[Drive Mode]→[Single Shooting].
  • Set [Audio Signal(Shooting)] to [Off] to turn off the beeping sound during the self-timer countdown.
  • To use the self-timer in the bracket mode, set the drive mode to bracket, then select MENU → (Shooting) → [Drive Mode] → [Bracket Settings] → [Selftimer during Bracket].
TP1001126940