List of messages after Auto Calibration measurements

  • Code 30 :
    Headphones are connected. Please disconnect the headphones and retry calibration.
  • Code 31 :
    The front speakers are not selected correctly. Select the correct front speaker configuration using SPEAKERS on the front panel of the receiver. Make sure that the receiver outputs sound and then try calibrating again.
  • Code 32, Code 33:
    • Sound is not detected from speakers.
      • Sound is not detected from one or both of the front speakers. Ensure the calibration microphone is not damaged, and is connected to the CALIBRATION MIC jack on the front panel of the receiver, and that all speakers are properly connected.
      • Sound is not detected from either the left or right surround speakers. Ensure both the surround speakers are connected to the SURROUND terminals.
      • A surround back speaker is connected only to the SURROUND BACK/HEIGHT R terminals. If connecting only one surround back speaker, connect it to the SURROUND BACK/HEIGHT L terminals.
      • Sound is not detected from either the left or right height speakers. Ensure both the height speakers are connected to the SURROUND BACK/HEIGHT terminals.
    • Sound is not detected from any speakers. Please ensure the calibration microphone is not damaged and its plug is inserted all the way into the CALIBRATION MIC jack on the front panel of the receiver.
  • Code 34 :
    The speakers are not placed in the proper positions. The left and right speakers or the left and right sides of the calibration microphone may be switched.
  • Code 35 :
    The speaker pattern configuration does not match calibration result. Please check the speaker pattern and connection.
  • Warning 40 :
    The measurement has been completed, but the noise level is high. For best results, calibrate in as quiet a place as possible.
  • Warning 41, Warning 42 :
    The input signal from the calibration microphone is too large. The microphone may be too close to the speakers. Please place the calibration microphone at your desired listening position. Please note, when using the receiver as a pre-amplifier, this message may appear by mistake. Please disregard.
  • Warning 43 :
    The distance and phase of the subwoofer cannot be detected. Please check the subwoofer and re-calibrate in a quiet environment.
  • Warning 44 :
    The measurement has been completed, but the speaker may need to be re-positioned.
Go to Page Top