Mounting Upright in a Fixed Location
This topic describes mounting the unit on a desktop or tripod.
Installation note
- To prevent unit failure, do not hold the camera head while working.
-
Check the mounting space.
When mounting on a desktop
Mount this unit on a flat surface, taking into consideration the space required for turning the camera head and the wiring at the rear of the unit.
Note
- Mount it in a stable location that is not subject to vibration. Locations subject to vibration may cause vibration in the image.
- If the unit must be mounted on an inclined surface, keep it within ±15° of the horizontal and take measures to prevent the unit from falling.
When mounting on a tripod
Attach the tripod to the tripod mounting screw hole on the bottom.
Use a tripod mounting screw with the following amount of protrusion from the mounting surface, and tighten it with a hand screwdriver.
A: Tripod mounting screw 1/4-20 UNC screw or 3/8-16 UNC screw
B: Protrusion (4.5 mm to 5.5 mm)
- Do not use tripod screws for mounting the unit in a high location.
TP1001804468
