Connecting an RM-IP500 Remote Controller via Wired LAN

  1. Set SETUP switch 4 of the unit to the ON position to enable VISCA over IP communication.

    Illustration of setup switches

    Note

    • The switch setting is applied when the unit is next turned on.
  2. Connect the RM-IP500 to the same network as the unit.
  3. Follow the procedure in the RM-IP500 operating instructions to configure VISCA over IP (LAN) connection on the RM-IP500.

    Assign this unit using RM menu > AUTO IP SETUP > ASSIGN CAM.

  4. Assign functions of this unit to buttons and knobs, as required, using the following RM menu items of the RM-IP500.

    SW ASSIGN

    AE CONFIG2

    WB MODE

  • For details about assigning functions, refer to the operating instructions for the RM-IP500.
  • For details about connecting via VISCA (RS-422 standard), see “Connecting to the Unit using a Remote Controller (Option) via RS-422.”
Go to Page Top
 
TP1001804706