[P/T Range Limit]

Sets settings related to limiting the pan/tilt operating range.

Set the pan/tilt operating range limits using the following screen.

Note

  • When the unit is turned on or pan/tilt reset is executed, this range limit setting is ignored. This function cannot be used to avoid obstacles near the unit.

  1. Set the [Setting] switch to the on position.

    The pan-tilt operating range limit function becomes enabled.

  2. Check the image using the pan/tilt controls of the camera.
  3. To set the positions at which to limit operation, press the [Left], [Right], [Up], [Down] – [Set Current Value] button at those positions.

    [Left]: Left side of camera

    [Right]: Right side of camera

    [Up]: Top side of camera

    [Down]: Bottom side of camera

    The limit positions are set and are displayed as numeric values (angle).

    To cancel a limit, press the [Reset] button for the individual positions.

  4. Press the [OK] button.

    The pan/tilt operation is restricted to stay within the configured limit positions.

Note

  • Camera positions outside the limit positions cannot be saved as a preset.
  • If the [Pan-Tilt] – [P/T Direction] – [Ceiling] setting is changed, the configured limit position settings are returned to the factory defaults.
  • The setting cannot be changed during playback, during thumbnail display, when a pan/tilt error occurs, and when pan/tilt is not initialized.
Go to Page Top
 
TP1001804668