Selecting the Audio Input Device

Set the following switches according to the device connected to the AUDIO IN connector.

  1. When a microphone is connected, set SETUP switch 2 on the connector block on the rear of the unit.

    CH-1 and CH-2 have common settings.

    Setting Description
    OFF (default) Select when using a dynamic microphone or battery-operated microphone. This turns off the +48 V phantom power supply and sets the LINE or MIC input as the CH-1 and CH-2 audio source.
    ON Select when using a +48 V phantom power supply compatible microphone. This turns on the +48V phantom power supply and sets the phantom power supply compatible microphone as the CH-1 and CH-2 audio source.
  2. Set the type of connected device using [Audio] > [Audio Input] > [AUDIO IN Select] in the camera menu.
  3. Select the audio input using [Audio] > [Audio Input] > [CH1 Input Select] to [CH4 Input Select] in the web menu or camera menu.

Note

  • Audio is not recorded in Interval Rec mode or Slow & Quick Motion mode.
Go to Page Top