One-to-One Connection Between the Unit and an RCP

Note

  • Refer to “List of Supported Functions” and configure the unit so that it meets the operating conditions for the functions you want to use, then enable the connection with an RCP using the following procedure.
  1. Turn each device on.
  2. Set [Technical] > [RCP/MSU] > [CNS Mode] to [Bridge] in the web menu of the camera.
  3. Configure the following settings on the RCP.
    1. Set the connection mode to Bridge mode.
    2. Register the IP address of the camera.

    For details about configuration, refer to the operating instructions of the RCP.

Go to Page Top