List of Supported Functions

The following table shows the supported functions and their corresponding operating conditions.

Operation panel Functions of the unit Operating conditions
IRIS Adjusting the iris manually –
AUTO IRIS Switching Auto Iris on/off –
ND Variable ND mode transmittance adjustment and preset position switching –
MASTER GAIN Adjusting the gain manually (3 dB units) Enabled when both the shooting mode is set to Custom mode and [Shooting] > [ISO/Gain/EI] > [Mode] is set to [dB] in the camera menu.
WHITE (R/B) Adjusting the white balance (R Gain/B Gain) manually Enabled when [White Mode] is set to [Memory A (R/B)] or [Memory A (T/T)].
WHITE (Color Temp) Adjusting the white balance (color temperature/tint) manually
  • RCP > [Color Temp]: White balance color temperature
  • RCP > [Balance]: White balance tint value
AWB White balance automatic adjustment –
ATW Switching the ATW (Auto Tracing White Balance) function on/off Enabled when the shooting mode is set to Custom mode.
BLACK R/B Adjusting the black balance Enabled when the shooting mode is set to Custom mode.
MASTER BLACK Adjusting the master black level
  • Enabled when the shooting mode is set to Custom mode.
  • H/V Ratio and Crispening are enabled when [Paint/Look] > [Detail] > [Manual Setting] is set to [On] in the camera menu.
  • To enable/disable the display function that distinguishes between the areas that are the target of multi matrix correction from an RCP, set [Paint/Look] > [Multi Matrix] > [Area Indication Control] to [Menu & RCP] in the camera menu.
  • The display function that distinguishes between the areas that are the target of multi matrix correction and BARS only operate in Bridge mode.
DETAIL
  • Switching the detail function on/off
  • Setting the detail level
  • Setting H/V Ratio
  • Setting Crispening
User Matrix
  • Switching the user matrix correction function on/off
  • Setting matrix correction values (R-G/R-B/G-R/G-B/B-R/B-G)
Multi Matrix
  • Switching the multi matrix correction function on/off
  • Setting the hue and saturation of the color used for multi matrix correction
  • Switching the display function between the areas that are the target of multi matrix correction on/off
Knee Switching the knee correction function on/off
Switching the auto knee function on/off
Setting the knee point and knee slope
BARS Switching the color bars on/off
SHUTTER
  • Switching the shutter function on/off
  • Setting the shutter speed value
    (Switching auto shutter on/off, setting angle shutter, setting slow shutter, setting ECS not supported.)

    Note

    • The RCP shutter settings may not be displayed depending on the configured shutter speed value.
    • The RCP shutter settings may not be displayed correctly if the shutter cannot be operated from the RCP.
 When auto shutter is on, auto shutter will continue to operate even if you turn the shutter on/off or change the shutter speed value from the RCP.
When the shutter is set to [Angle], turning the shutter on/off or changing the shutter speed setting from the RCP is not supported.
CALL/Tally Supports display of CALL/Tally function Enabled when [Technical] > [Tally] > [Tally Control] is set to [External] in the web menu.

Note

  • After configuring the unit to satisfy the operating conditions of the function you want to use, enable the connection between the unit and the RCP/MSU/CNA-2. If the operating conditions are adjusted after the connection is enabled, unintended behavior may occur.
Go to Page Top