About Streaming
The unit can simultaneously stream the video and audio that is output from the HDMI connector.
Note
- To use streaming as the main video, set [Monitoring] > [Output Display] > [SDI] to [On] and [HDMI/Stream] to [Off] in the web menu, and monitor the camera status on an SDI monitor.
- If a monitor connected to the HDMI connector does not support the HDMI output format configured using the [Monitoring] menu in the web menu or camera menu, the camera image will not be output to the Web App. Streaming video also cannot be output.
- The streaming resolution cannot be set higher than the HDMI output signal resolution.
- When viewed by multiple users, the image may become distorted depending on the codec settings.
The unit supports the following streaming methods. The video codecs available for selection are shown in parentheses.
- RTSP (H.264, H.265)
- RTMP (H.264)*1
- SRT-Caller (H.264)
- SRT-Listener (H.264)
- NDI|HX (H.264, H.265)
Configure the streaming format setting, video codec setting, and audio codec setting in that order.
| Streaming format | Codec setting | |||
|---|---|---|---|---|
| Video Stream 1 | Video Stream 2 | Video Stream 3 | Audio Stream | |
| RTSP | ● video 1 |
●*2 video 2 |
– | ● |
| RTMP | ● | – | – | ●*1 |
| SRT | ● | – | – | ● |
| NDI|HX | ● Main |
● Sub |
– | ● |
| Web App | – | – | ● | – |
●: Enabled, –: Disabled
*1RTMP can be selected when [Stream] > [Audio Stream] is set to [On] in the web menu.
*2When the system frequency is 59.94 or 50 and the HDMI output format is 3840×2160 or higher, video 2 output is not available.
Hint
- The image in the Web App camera image panel is also a streaming system.
