Well Properties Dialog
The well properties dialog is used to edit the sample information, add keywords to the sample, and check the sample status.
The well properties dialog is displayed by clicking 
of [Sample] on the [Analysis] tab of the ribbon, or right-clicking a well in the [Plate] panel and selecting [Properties].
-
[Sample Information]
You can edit information about a sample.
[Name]
Enter the name of the well.
[Cell (optional)]
Enter information about the cell, as required.
[Condition (optional)]
Enter the condition of the sample, as required.
[Memo (optional)]
Enter a comment, as required.
-
[Sample Keywords]
You can edit the sample keywords for the keyword names set in an experiment.
[Name]
Displays the keyword names configured in the experiment.
[Value]
Enter a sample keyword.
-
[Sample Status]
Displays the acquisition status of the sample.
[Status]
Displays the acquisition status of the sample.
[Acquisition Date]
Displays the acquisition date and time.
[Acquisition Condition]
Displays the acquisition end condition.
- [Normal]: Acquisition ended successfully.
- [Low Event Rate]: A low event rate or reducing event rate was detected.
- [Air]: Air bubbles have been detected.
- [Elapsed Time Limit]: The upper limit of acquisition time has been reached.
[Total Events]
Displays the number of events.
[Aborted Events]
Displays the number of aborted events and their percentage.
[Worksheet Mode]
Displays the worksheet sharing mode.
[Unmixing Cache]
Displays whether data for which fluorescence unmixing calculation has completed exists.
-
[Sample Settings]
Displays settings related to sample acquisition.
[Sample Group]
Selects the sample group to which the sample belongs.
[Auto acquisition target]
Place a check mark in the checkbox when automatically acquired well.
-
[OK]
Saves the settings and closes the dialog.
-
[Cancel]
Cancels the settings and closes the dialog.
